APC AP9622 Bedienungsanleitung PDF herunterladen

Installing Multiple Management Cards

Overview

When installing more than one APC management card, you must install the

cards in the order described in this document because they share a serial link

with the connected UPS. Installing the cards in any other order may result in

failure for them to operate properly.

Before you start

The following table identifies the priority of the management cards you will be

installing. Management cards that have more control over the UPS have higher

priority.

• Level 6: Exerts total control

• Level 5: Exerts wide, but not total, control

• Level 4: Exerts limited control

• Level 3: Passes commands to the UPS

• Level 2: Exerts no control

• Level 1: Exerts no control and must be installed closest to the UPS

Management Card Priority

Network Management Card

(AP9617, AP9618,

AP9619, AP9630, AP9631)

Level 6

Out-of-Band Management Card (AP9608) Level 5

Relay I/O Module (AP9610) Level 4

Interface Expander Card (AP9607) Level 3

Building Management Integration Card

(AP9622) Level 2

Environmental Monitoring Card (AP9612TH) Level 1

1. Attach no more than two Network Management Cards to a UPS.

2. Attach only one Building Management Integration Card to a

UPS.

1 2 3 4

Management Port 2

Inhaltsverzeichnis

Seite 1

Installing Multiple Management CardsOverviewWhen installing more than one APC management card, you must install the cards in the order described in th

Seite 2 - Management Port

2Installing Multiple Management CardsTwo models of expansion chassisIf you need management card slots in addition to those in your UPS, use one or mor

Seite 3

Installing Multiple Management Cards3Installing cards in a Symmetra UPSIf you are installing a Network Management Card without an attached expansion c

Seite 4