APC NBRK0550 Installationsanleitung PDF herunterladen (Seite 11)

NetBotz Wireless Temperature Sensor Installation Guide

Scanning with a USB QR code scanner. When you use a USB QR code

scanner with document capture capabilities, only the extended address (MAC)

of each Wireless Temperature Sensor will appear in the list in Advanced View

in the correct format.

1. Attach a hand-held USB QR code scanner with document capture

capabilities to a computer running the NetBotz Advanced View.

2. With the Advanced View open to the “Add Addresses” dialog in the

Wireless Sensor Setup task, scan the QR code on the label of each

Wireless Temperature Sensor.

3. Click Apply Commission List to save the list to the NetBotz appliance.

Note: Depending on the appliance, you can add up to 26 or up to

48 wireless devices, including the Coordinator and Routers, to your

wireless sensor network. For more information, see “Supported

devices on the NetBotz wireless network” on page 2.

Mount the sensors. Mount the Wireless Temperature Sensors using the

instructions in “Mounting the Wireless Temperature Sensor” on page 11.

Power the sensors. Turn the Wireless Temperature Sensor on using the

rocker switch on its side.

The sensor will scan all channels, and wait for a response from the Coordinator.

It will then send a request to join the wireless network.

The request to join the network will be accepted or will fail based on whether

the sensor’s extended address (MAC) is in the same list in Advanced View as

the Coordinator, and whether the device limit on your wireless network has

been reached.

Once the request is accepted, the sensor will join the wireless network.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Keine Kommentare

APC NBRK0550 Installationsanleitung Seite 11