APC NetShelter VX Spezifikationen PDF herunterladen (Seite 26)

NetShelter SX Enclosure: Unpacking, Installation, and Customization22

Installing Equipment

This section provides information on how to install rack-mount equipment in the NetShelter SX

enclosure. The instructions provided with the equipment provide more detailed information.

Identifying one U-space on the vertical mounting flange

When installing equipment, locate the top and bottom of a U-space on the mounting flanges. Every third

hole on the mounting flanges of a NetShelter enclosure is numbered to indicate the middle of a U-space.

A U-space consists of one of these numbered holes and one hole directly above and below it, as shown.

Installing cage nuts

APC offers a cage nut hardware kit (AR8100) for use with square holes.

Warning: Install cage nuts horizontally, with the ears engaging the sides of the square

hole. Do NOT install cage nuts vertically with the ears engaging the top and bottom of

the square hole.

1. Insert the cage nut into the square hole by hooking one ear of the cage nut assembly through the

far side of the hole.

Note: Install the cage nuts on the interior of the vertical mounting flange.

2. Place the cage nut tool (provided) on the other side

of the cage nut and pull to snap it into position.

Removing cage nuts

1. Remove any attached screw.

2. Grasp the cage nut and squeeze the sides to release

it from the square hole.

1 U

ns0014a

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 43 44

Keine Kommentare

APC NetShelter VX Spezifikationen Seite 26