APC CM Series Bedienungsanleitung PDF herunterladen (Seite 17)

12 APC NetworkAIR CM Series: Optional Features

Environmental monitoring unit. A stand-alone unit performs continuous

temperature and humidity sensing through two available probes (one

included) and contact monitoring. The unit is controlled by available web,

control console, or SNMP interface with network connection. In the event of

an environmental anomaly, notification is sent to the customer via e-mail or

SNMP. The unit is 18.25" × 9" × 2.75" (464 mm × 229 mm × 70 mm) and sits

in or on top of a rack. The probes extend up to 12' (3.66 m) from the unit.

Airflow sensor. The air proving switch is continuously monitored by the

microprocessor. Upon detection of a loss of air flow the microprocessor will

deactivate: cooling, heating, humidification and dehumidification. After the

air flow has been restored for a predetermined period of time the

microprocessor will reactivate the functions as needed. Comes standard with

microprocessor.

Reheat Hot water or steam reheat. An on/off solenoid valve for steam reheat, or a

modulating valve for hot water reheat maintains the dry bulb temperature

when the system is in dehumidification and heat mode. Completely factory

pre-piped, the system includes a copper tube, aluminum-fin reheat coil,

solenoid valve, float, and thermostatic and steam trap for steam reheat only.

Hot gas reheat. The copper tube, aluminum fin hot gas reheat coil

maintains the leaving dry bulb temperature when the system is in the

dehumidification mode. The coil is controlled by the microprocessor through

a factory-piped-and-wired three-way heat reclaim regulator and check valve

(water/glycol only.)

System Components High efficiency filter(s). Pleated final filters with an efficiency of 40% and

60% (ASHRAE 52.2), 4" (102 mm) deep, allow the removal of a greater

percentage of airborne particulate contaminates (4–5 ton units.)

Prefilter(s). Intended to capture large airborne particulate contaminates,

thereby extending the life of the high-efficiency filter. Prefilters are 1" (25

mm) deep and easily disposable.

Condensate pump. The condensate pump, shipped loose, will pump 36 gal/

h (0.06 L/s) at 15' (4.6 m) head.

High pressure water regulating valve(s). Water and glycol systems may

utilize an optional regulating valve, which operates with a maximum pressure

of 350 psi (2400 kPa), to automatically control condensing temperature.

Flared filter-drier connection. Flared threaded connections can be

provided on either side of the filter drier to expedite replacement.

Hot gas bypass. An auxiliary side-port hot gas bypass circuit. The

activation of the hot gas bypass circuit will maintain the evaporator coil

temperature during low load conditions. This optional feature will offer

longer compressor run times and minimize compressor cycling and

temperature fluctuations.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 72 73

Keine Kommentare

APC CM Series Bedienungsanleitung Seite 17