APC AP9613 Installationshandbuch PDF herunterladen (Seite 13)

Installation Manual

Quick Configuration

Overview

Disregard the procedures described in this chapter if you have

StruxureWare Central as part of your system. See the documentation for

your StruxureWare device for more information.

You must configure the following TCP/IP settings before the UPS Network

Management Card (NMC) can operate on a network:

• IP address of the NMC

• Subnet mask

• Default gateway

If a default gateway is unavailable, use the IP address of a computer that

is located on the same subnet as the NMC and that is usually running.

The NMC uses the default gateway to test the network when traffic is

very light.

Do not use the loopback address (127.0.0.1) as the default gateway

address for the NMC. It disables the card and requires you to reset TCP/

IP settings to their defaults using a local serial login.

See “Watchdog Features” in the “Introduction” of the NMC User’s

Guide for more information about the watchdog role of the default

gateway.

TCP/IP configuration methods

Use one of the following methods to define the TCP/IP settings needed by the

Network Management Card for IPv4:

• “Device IP Configuration Utility” on page 10

• “How to Recover from a Lost Password” on page 15

• Networked computer:

– “Local access to the command line interface” on page 12

– “Remote access to the command line interface” on page 13

DMP IM 990-3404.book Page 9 Monday, March 11, 2013 9:05 AM

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Keine Kommentare

APC AP9613 Installationshandbuch Seite 13