APC AP9613 Installationshandbuch PDF herunterladen (Seite 19)

Installation Manual

How to Recover from a Lost Password

You can use a local computer that connects to the Network Management Card

through the serial port to access the command line interface.

1. Select a serial port at the local computer, and disable any service that uses

that port.

2. Connect the provided serial cable (part number 940-0299) to the selected

port at the computer and to the configuration port at the Network

Management Card.

3. Run a terminal program (such as HyperTerminal

) and configure the

selected port for 9600 bps, 8 data bits, no parity, 1 stop bit, and no flow

control.

4. Press

ENTER, repeatedly if necessary, to display the User Name prompt. If

you are unable to display the User Name prompt, verify the following:

– The serial port is not in use by another application.

– The terminal settings are correct as specified in step 3.

– The correct cable is being used as specified in step 2.

5. Press the

Reset button. The Status LED will flash alternately orange and

green. Press the

Reset button a second time immediately while the LED is

flashing to reset the user name and password to their defaults temporarily.

6. Press

ENTER, repeatedly if necessary, to display the User Name prompt

again, then use the default,

apc, for the user name and password. (If you

take longer than 30 seconds to log on after the User Name prompt is

redisplayed, you must repeat step 5 and log on again.)

7. At the command line interface, use the following commands to change the

Password setting, which is

apc at this stage:

user -n <user name> -pw <user password>

For example, to change the Super User password

XYZ, type:

user -n

apc -pw XYZ

8. Type quit or exit to log off, reconnect any serial cable you

disconnected, and restart any service you disabled.

DMP IM 990-3404.book Page 15 Monday, March 11, 2013 9:05 AM

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 35 36

Keine Kommentare

APC AP9613 Installationshandbuch Seite 19