APC Network Management Card AP9617 Betriebsanweisung PDF herunterladen (Seite 21)

®®

USER’S GUIDE

network management card

How to Recover from a Lost Password

You can use a local computer, a computer that connects to the Management

Card through the serial port at the Management Card’s UPS or expansion

chassis, to access the control console.

1. Select a serial port at the local computer and disable any service which

uses that port.

2. Unless an APC smart-signaling cable (940-0024 or 940-1524) is

already connected to the selected port, connect the smart-signaling

cable that came with the Management Card to the selected port and to

the serial port at the Management Card’s UPS or chassis.

3. Run a terminal program (such as HyperTerminal) and configure the

selected port for 2400 bps, 8 data bits, no parity, 1 stop bit, and no flow

control, and save the changes.

4. Press

ENTER to display the User Name prompt.

5. Press the Reset button on the Management Card, which causes the

Management Card to restart, a process that typically takes five to ten

seconds.

6. Press

ENTER as many times as necessary to redisplay the User Name

prompt, then use apc for the User Name and Password. (If you take

longer than 30 seconds to log on after the User Name prompt is

redisplayed, you must repeat steps 4 and 5.)

7. From the Control Console menu, select System, then User Manager.

8. Select Administrator, and change the User Name and Password

settings, both of which are now defined as apc.

9. Press

CTRL-C and log off. You must perform the entire procedure (log

on, change the user name and password, and log off) within two

minutes so that you are not logged off for inactivity. If you are logged off

automatically, the new settings will not take effect, and you must repeat

the entire procedure from the beginning.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 149 150

Keine Kommentare

APC Network Management Card AP9617 Betriebsanweisung Seite 21