APC ACRC301S Betriebsanweisung PDF herunterladen (Seite 11)

Operation: Using the Display

InfraStruXure InRow RC—Operation and Maintenance 5

Start the cooling unit

Path: Main Menu > On/Standby

To start the cooling unit, select the On/Standby option on the main

menu and change the setting to On. The cooling unit will run according

to the configured settings.

Stop the cooling unit

Path: Main Menu > On/Standby

To put the cooling unit into Standby mode, select the On/Standby option on the main menu and change

the setting to Standby.

Factory default settings

All the InRow RC settings are controlled through the display interface on the front of the InRow RC. The

factory default temperature is set at 72°F (22.2°C).

The default PID coefficient values for the RC's Cool (Fan

Speed) PID are:

Gain (P) = 0.67

Rate (I) = 0.37

Deriv (D) = 0.26

Note

On/Standby only affects the local cooling unit. You

must set the On/Standby option for each cooling unit

in the cooling group.

On/Standby

View Alarms

Clear Alarms

View Event Log

na1641a

Clear Event Log

Configure Modbus

Set Date & Time

Set Password

Set Display Units

Configure Display

Configure Network

About InRow RC

Set Identification

Service Intervals

View Run Hours

Configure Unit

Configure Group

Set Group PID

View Group Status

View Unit Status

Set Group Setpoints

Set Unit Thresholds

Warning

The Standby option does not remove power from the cooling unit. The cooling unit

has two power sources. You must disconnect both Power A and Power B to remove

power from the cooling unit.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare

APC ACRC301S Betriebsanweisung Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Split-System-Klimaanlagen APC ACRC301S