APC ACRC301S Betriebsanweisung PDF herunterladen (Seite 43)

Network Management Card: How to Recover From a Lost Password

InfraStruXure InRow RC—Operation and Maintenance 37

If you are unable to display the User Name prompt, verify the following:

– The serial port is not in use by another application.

– The terminal settings are correct as specified in step 3.

– The correct cable is being used as specified in step 2.

5. Press the Reset button on the electrical panel. The Status LED will flash alternately orange and

green. Immediately press the Reset button on the electrical panel a second time while the LED is

flashing to reset the user name and password to their defaults temporarily.

6. Press

ENTER as many times as necessary to redisplay the User Name prompt, then use the default,

apc, for the user name and password. (If you take longer than 30 seconds to log on after the User

Name prompt is redisplayed, you must repeat step 5 and log on again.)

7. From the Control Console menu, select System, then User Manager.

8. Select Administrator, and change the User Name and Password settings, both of which are now

defined as apc. Select Accept Changes to store the new user name and password values.

9. Press

CTRL-C, log off, reconnect any serial cable you disconnected, restart any service you disabled,

reinstall the lower air filter, and replace the rear panel.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 59 60

Keine Kommentare

APC ACRC301S Betriebsanweisung Seite 43