APC IP DSLAM Betriebsanweisung PDF herunterladen (Seite 285)

100

101

277

It ranges from 0 to 255 seconds.

Conf PML2 Time(sec)

PM configuration parameter, related to the L2

low power state. This parameter represents the

minimum time (in seconds) between an Entry

into the L2 state and the first Power Trim in the

L2 state and between two consecutive Power

Trims in the L2 State. It ranges from 0 to 255

seconds.

Conf PML2 ATPR

(dB/10)

PM configuration parameter, related to the L2

low power state. This parameter represents the

maximum aggregate transmit power reduction

(in dB) that can be performed through a single

Power Trim in the L2 state. It ranges from 0

dB/10 to 310 dB/10.

Conf PML2 Min

Rate(bps)

PM configuration parameter, related to the L2

low power state. This parameter specifies the

minimum net data rate during the low power

state (L2). The data rate is coded in bit/s, and

can range from 0x1F40 (8000) bps to 0xFA000

(1024000) bps.

MSG Min Ds

Configures downstream overhead channel

bandwidth. This feature is not supported by

DSLPHY as yet.

Min Snr Mrg(dB/10)

Atuc Configured Minimum Signal/Noise Margin.

This is the Noise Margin, the modem must

achieve with a BER of 10 to the power -7 or

better, to successfully complete initialization.

The default value mentioned is an indicative

value only.

FrontEnd H/W Design

Front end hardware reference design

H/W Pwr Reduction

Hardware configuration parameter

GsUsBitSwap

This parameter enables/disables upstream bit

swapping

Minimum INP

Parameter used to specify the minimum impulse

noise protection for the downstream bearer

channel.

PML2 Entry Thresh

Rate

PM config param. L2 state entry data rate.

PML2 Exit Thresh Rate

PM config param. L2 state exit data rate.

PML2 Entry Rate Min

Time

PM config param.Min L2 entry rate time

CabinetHsEnable

Enable/Disable HS tones in Cabinet mode

GsSeltLoopType

Conexant parameter that is used to specify the

loop type for SELT. The default value mentioned

is an indicative value only.

GsRxStartBinU1

Conexant parameter that specifies lowest bin

number allowed for Rx signal in G.Span Plus

SUQ mode. By selecting the receive start and

end bin numbers, the user can limit the bins for

special configurations.(length = 4 bytes)

GsRxEndBinU1

Conexant parameter that specifies highest bin

number allowed for Rx signal in G.Span Plus

SUQ mode. By selecting the receive start and

end bin numbers, the user can limit the bins for

special configurations.(length = 4 bytes)

PSD MoD Enable

Conexant parameter that is used to configure

the switching point between DBM-OL and

XOL.(length = 4 bytes)

PsdMod

FallBackEnable

Conexant parameter used to enable Mask on

Demand (MoD) fallback mode. When enabled,

1 2 ... 280 281 282 283 284 285 286 287 288 289 290 ... 602 603

Kommentare zu diesen Handbüchern

Keine Kommentare

APC IP DSLAM Betriebsanweisung Seite 285

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung APC IP DSLAM