APC IP DSLAM Betriebsanweisung Seite 467

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 603
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 466
459
Type: Create Optional
Modify Optional
Valid values: 0 -10
Default value: 5
lowiftoggletimerto
<lowiftoggletimerto-val>
Time in seconds to wait for lowif to come up
without tearing down the pppr session.
Type: Create Optional
Modify Optional
Valid values: 0 – 10
Default value: 5
nature dynamic |
static
Specifies if the interface is dynamic or static in
nature.
Type: Create Optional
Modify Optional
Default value: Dynamic
configstatus Normal
|Config
This mode describes the configuration status for
the interface. If the "config" bit is set, this interface
shall be created, but will have a dormant status.
Only after the receipt of an pppoa packet from the
CPE side, this interface shall become active.
Type: Create Optional
Modify Optional
Default value: Normal
enable | disable
Administrative status of the interface
Type: Optional
Valid values: enable or disable
Default Value: enable
pktpriority <pktpriority-
val>
Priority to be set in tagged PPPOE frames or PPP
packets sent over this port from Control
Plane .This priority shall also be used for choice of
traffic class/ Queue on outgoing interface whether
the frame is tagged or not.In case the bridge port
is over an Aggregated ATM VC, this will also be
used to identify the VC, on which the packet is to
be sent.
Type: Create Optional
Modify Optional
Valid values: 0 – 7
Default value: 0
Example
$ create pppr intf ifname pppr-0 lowif aal5-0 maxPdu 1484 ppprAckTO
10 lowifToggleTimerTO 10 nature dynamic configstatus Normal
Output
Verbose Mode On
Entry Created
Ifname : pppr-0 Low IfName : aal5-0
Max PDU Size : 1484 Ter Ack TimeOut : 10
Lowif Toggle TimeOut : 10
Nature : dynamic Config Status : Normal
Operational Status : up Admin Status : up
PPPOA PacketsPrio:2
Verbose Mode Off:
Entry Created
Output Fields
FIELD Description
Ifname
The PPPR interface.
Low IfName
This specifies the name of the lower AAL5
interface.
Max PDU Size
This specifies the maximum PDU size on a PPPR
interface.
Seitenansicht 466
1 2 ... 462 463 464 465 466 467 468 469 470 471 472 ... 602 603

Kommentare zu diesen Handbüchern

Keine Kommentare